User's Manual

Chapter 4: Web Configuration
31
WEP Key Format: For WEP 64 bits and WEP 128 bits encryption type,
the selection of WEP Key Format are Hex and ASCII.
WEP Key: If select Hex if you are using hexadecimal numbers (0-9, or A-F).
Select ASCII if you are using ASCII characters (case-sensitive).
 Hexadecimal (WEP 64 bits): 10 Hex characters (0~9, a~f).
 Hexadecimal (WEP 128 bits): 26 Hex characters (0~9, a~f).
 ASCII (WEP 64 bits): 5 ASCII characters (case-sensitive).
 ASCII (WEP 128 bits): 13 ASCII characters (case-sensitive).
WPA2
Pre-Shared Key Format: The Pre-shared Key Format will be enabled
when WPA (TKIP) and WPA2 (AES) encryption be selected. There are
two formats for choice to set the Pre-shared key, Passphrase and Hex (64
characters). If Hex is selected, users will have to enter a 64 characters
string. For easier configuration, the Passphrase (at least 8 characters) format
is recommended.
Pre-Shared Key: Pre-Shared-Key serves as a password. Users may key in 8
to 63 characters string to set the passwords or leave it blank, in which the
802.1x Authentication will be activated. Make sure the same password is
used on client's end.
Show Statistics
Click Show Statistics to show the current WDS AP table. This table shows
the MAC address, transmission packets and errors, reception packets and Tx
Rate (Mbps) counters for each configured WDS AP.
Refresh: Click to renew the counters information.
Close: Click to leave the screen.
Current WDS
AP List
Here shows the current WDS AP information.
Delete Selected
Click Delete Selected to delete the selected AP information.
Delete All
Click Delete All to delete all the items.
Reset
Click Reset to restore the settings.