User's Manual

TCP/IP

IP Address

Default: 192.168.1.254 (this is the local address of this Router)

Subnet Mask

Default: 255.255.255.0

Default Gateway

Shows the default gateway IP address.

DHCP

Disable: Select to disable this Router to distribute IP Addresses

(Disabled)

Server: Select to enable this Router to distribute IP Addresses

(DHCP Server). And the following field will be activated for

you to enter the starting IP Address

DHCP Client Range The starting address of this local IP network address pool.

The pool is a piece of continuous IP address segment. Keep

the default value 192.168.1.1 should work for most cases.

• Maximum: 253. Default value 253 should work

for most cases.

Note: If “Continuous IP address poll starts” is set at

192.168.1.1 and the “Number of IP address in pool” is 253,

the device will distribute IP addresses from 192.168.1.1 to

192.168.1.253 to all the computers in the network that request

IP addresses from DHCP server (Router)

Show Client Click to show Active DHCP Client table.

DNS Server Enter the Domain Name Service IP address.

Clone MAC Address

You can specify the MAC address of your Access Point to

replace the factory setting.

Apply Changes

After completing the settings on this page, click to save the

settings.

Reset

Click to restore to default values.