User's Manual

13
system will automatically fall back to a lower rate.
Preamble Type: A preamble is a signal used in wireless environment to
synchronize the transmitting timing including Synchronization and Start
frame delimiter. (Note: If you want to change the Preamble type into Long
or Short, please check the setting of AP)
Broadcast SSID
Enable: This Wireless Router will broadcast its SSID to stations.
Disable: This Wireless Router will not broadcast its SSID to stations. If stations
want to connect to this Wireless Router, this Wireless Router’s SSID should be
known in advance to make a connection.
Apply Changes: Click to save and apply the current setting.
Reset: Click to clear and reset the current settings.
Access
Control
Click to enter the Access Control screen.
Wireless Access Control Mode: Select the Access Control Mode from the
pull-down menu.
• Disable: Select to disable Wireless Access Control Mode.
• Allow Listed: Only the stations shown in the table can associate
with the Wireless Router.
Deny Listed: Stations shown in the table won’t be able to associate with the
Wireless Router.
MAC Address: Enter the MAC Address of a station that is allowed to
access this Access Point.
Comment: You may enter up to 20 characters as a remark to the previous
MAC Address.
Apply Changes: Press to save the new settings on the screen.
Reset: Press to discard the data you have entered since last time you press
Apply Change.
Delete Selected: To delete clients from access to this Access Point, you
may firstly check the Select checkbox next to the MAC address and
Comments, and press Delete Selected.
Delete All: To delete all the clients from access to this Access Point, just
press Delete All without selecting the checkbox.
Reset: If you have made any selection, press Reset will clear all the select
mark.