User's Manual

12
has access to a user database with authentication information.
Port: Enter the RADIUS Server’s port number provided by your ISP. The
default is 1812.
IP Address: Enter the RADIUS Server’s IP Address provided by your ISP.
Password: Enter the password that the AP shares with the RADIUS Server.
Enable Accounting: Check to enable this function.
Accounting RADIUS Server
Port: Enter the RADIUS Server’s port number provided by your ISP. The
default is 1812.
IP Address: Enter the RADIUS Server’s IP Address provided by your ISP.
Password: Enter the password that the AP shares with the RADIUS Server.
Apply Changes: Click to save and apply the current settings.
Reset: Click to clear and reset the current settings.
Advanced
Settings
Fragment Threshold: Fragmentation mechanism is used for improving the
efficiency when high traffic flows along in the wireless network. If your
Wireless Router often transmits large files in wireless network, you can
enter new Fragment Threshold value to split the packet. The value can be
set from 256 to 2346. The default value is 2346.
RTS Threshold: RTS stands for “Request to Send”. This parameter controls
what size data packet the low level RF protocol issues to an RTS packet. The
default is 2346. The RTS Threshold mechanism provides a solution to
prevent data collisions. When you enable RTS Threshold on a suspect
“hidden station”, this station and its Portable Router will use a Request to
Send (RTS). The station will send an RTS to the Access Point, informing
that it is going to transmit the data. Upon receipt, the Access Point will
respond with a CTS message to all station within its range to notify all other
stations to defer transmission. It will also confirm the requestor station that
the Access Point has reserved it for the time-frame of the requested
transmission.
Beacon Interval: Enter a value between 20-1024 milliseconds. The Beacon
Interval value indicates the frequency interval of the beacon. A beacon is a
packet broadcast by the Router to synchronize the wireless network. The
default value is 100.
Inactivity Time:
Data Rate: By default, the unit adaptively selects the highest possible rate
for transmission. Select the basic rates to be used among the following
options: Auto, 1, 2, 5.5, 11or 54 Mbps. For most networks the default setting
is Auto which is the best choice. When Auto is enabled the transmission
rate will select the o
p
ti
m
al rate. If obstacles or interference are
p
resent
,
the