User's Manual

If the “Hidden Node” problem is an issue, please specify the packet size. The

RTS mechanism will be activated if the data size exceeds the value you set..

The default value is 2347.

Warning: Enabling RTS Threshold will cause redundant network

overhead that could negatively affect the throughput performance instead

of providing a remedy.

This value should remain at its default setting of 2347. Should you encounter

inconsistent data flow, only minor modifications of this value are recommended.

Beacon Interval: Beacon Interval is the amount of time between beacon

transmissions. Before a station enters power save mode, the station needs the

beacon interval to know when to wake up to receive the beacon (and learn

whether there are buffered frames at the access point).

Inactivity Time:

Data Rate: By default, the unit adaptively selects the highest possible rate

for transmission. Select the basic rates to be used among the following

options: Auto, 1, 2, 5.5, 11or 54 Mbps. For most networks the default setting

is Auto which is the best choice. When Auto is enabled the transmission rate

will select the optimal rate. If obstacles or interference are present, the

system will automatically fall back to a lower rate.

Preamble Type: A preamble is a signal used in wireless environment to

synchronize the transmitting timing including Synchronization and Start

frame delimiter. (Note: If you want to change the Preamble type into Long

or Short, please check the setting of AP)

Broadcast SSID:

Enable: This wireless AP will broadcast its SSID to stations.

Disable: This wireless AP will not broadcast its SSID to stations. If stations want to connect

to this wireless AP, this AP’s SSID should be known in advance to make a connection.

Apply Changes: Click to save and apply the current setting.

Reset: Click to clear and reset the current settings.

Access

Control

Click to enter the Access Control screen.

Wireless Access Control Mode: Select the Access Control Mode from the

pull-down menu.

• Disable: Select to disable Wireless Access Control Mode.

• Allow Listed: Only the stations shown in the table can associate

with the AP.

Deny Listed: Stations shown in the table won’t be able to associate with the

AP.

MAC Address: Enter the MAC Address of a station that is allowed to

access this Access Point.

Comment: You ma

enter u

to 20 characters as a remark to the

revious