User's Manual

- 9 -
HARDWARE INSTALLATION
Note: The hardware installation should be only performed when the software is well
installed.
Precaution
Before the installation, make sure the USB port exists in your computer and is enabled. To
check this, go to My Computer
 Control Panel  System. Open the Device Manager tab. If
the Universal Serial Bus controller device is found, it means your USB port is installed and
enabled. If not, either no USB port is installed or the USB bios is not properly enabled. In this
case, consult your computer dealer for USB support.
Getting Hooked Up
1. If the device is connected to the USB port on a desktop computer, use the included USB
adapter cable to connect your Bluetooth
TM
USB Adapter with your computer.
2. Firstly, you have to locate the USB host port of your system. Align the USB connector
(the thinner end) of the USB adapter toward the USB host port, push evenly and steadily
until it is seated.
3. Plug your Bluetooth
TM
USB Adapter into the thicker end of the USB adapter cable.