User's Manual

 Ensure your DNS setting are correct.

Wireless Station Configuration

 This section applies to all wireless stations wishing to use the HomePlugAV’s

wireless, regardless of the operating system that is used on the client.

 To use the HomePlugAV, each wireless station must have compatible settings, as

following:

Mode Must be set to Infrastructure mode.

SSID (ESSID) The network name must match the value used on the HomePlugAV.

Notes: The SSID is case sensitive.

Open Shared Key If there is no security is enabled on the HomePlugAV, the security of

each station should be disabled as well. And, you can connect the

HomePlugAV without security, but it is NOT recommended.

WEP auto By default, WEP on the HomePlugAV is disabled.

 If WEP remains disabled on the HomePlugAV, each station must

have WEP disabled.

 If WEP is enabled on the HomePlugAV, each station must use the

same settings as the HomePlugAV.

WPA-PSK and

WPA2-PSK

WPA-PSK (TKIP/AES) / WPA2-PSK (TKIP/AES): If one of these

securities is enabled on the HomePlugAV, each station must use the

same algorithms and pass phrase as the HomePlugAV to make a

connection.

Note: By default, the HomePlugAV will allow 802.11b, 8021.g and 802.11n connection.

ireless Station Configuration