User's Manual

2.3 Wireless Settings

Use this page to configure the parameters for wireless LAN clients that may connect to

your HomePlugAV.

Basic setting

Enable

Wireless LAN

Interface

Check to turn on/off the radio function.

Mode

Select WiFi 11g, WiFi 11gn HT20, WiFi 11gn HT40+ or WiFi 11gn HT40-

from pull-down menu. (WiFi 11gn HT40+ is the default setting.)

SSID

A SSID is referred to a network name because essentially it is a name that

identifies a wireless network. Maximum input is 32 characters.

Channel

Bandwidth

Select 40/20MHz or 20MHz. HT20/40 is the Default setting.

Channel

Select preferred channel from pull-down menu. CH6 is the Default setting.

Broadcast

SSID

Enable: This HomePlugAV will broadcast its SSID to stations.

Disable: This HomePlugAV will not broadcast its SSID to stations. If stations

want to connect to this device, this HomePlugAV ’s SSID should be known

in advance to make a connection.

Save

After completing the setting on this page, click Save button to save the

settings.

Reset

Back to last saved data.

2.3

ireless Settings