User's Manual

17. For the first time installation, you need to go
to the Network in the Control Panel to setup
the protocols, clients and services properly
according to your need.
Note: If you start the computer without the CardBus
10/100 Ethernet PC Card installed in the socket, the
native Windows 95 system will prompt you the warning
message “Your Network Adapter CardBus Fast
Ethernet 10/100 Adapter manual load” [0001] is not
working properly. You may need to set it up again.
For more information, see the network
troubleshooting in the windows Help”.
If you don’t need to use the CardBus 10/100 PC Card at
this time, you can just ignore the message. Otherwise,
you need to insert the CardBus 10/100 Ethernet PC Card
into the CardBus socket and just restart the native
Windows 95 again to make the Card work functionally.
OSR2 Windows 95 and Later
Windows 95 OSR2 and later versions support both
CardBus and 16-bit PC Card. That is, you could
run the 16-bit PC Card and CardBus 10/100M
Ethernet PC Card simultaneously with the
plug-n-play support. In addition to the plug n-play
support of both types of PC Card, the user also
could perform the Hot Swap function provided by
the Card and Socket Service built in the OSR2
Windows 95 or later.
1. After the Windows 95 OSR2 is successfully
booting, insert the CardBus 10/100 Ethernet
PC Card into the CardBus Socket.
2. Click Next on Update Device Drivers
Winzard.
- 12 -