User's Manual

~Static configuration: Check this button when the ISP assigns static IP address for your
account.
PPPoE Account Info (enter information provided by ISP when PPPoE is selected)
Username:
• Maximum input is 52 alphanumeric characters (case sensitive).
Password:
• Maximum input is 36 alphanumeric characters (case sensitive).
Service Name: For identification purpose. If it is required, your ISP will provide you the
information.
Auto-disconnect: This device can be configured to auto-disconnect when there is no activity
on the line for a predetermined period of time.
• Default: 5 minutes. You can input any number from 0 to 65535.
• To keep the line always connected, please set the number to 0.
Link Status (Read-Only): Displays the current PPPoE link status (for PPPoE only). It
shows either “PPPoE connected” or “PPPoE disconnected”.
Internet Port Configuration: For CATV dynamic mode or PPPoE (DSL dynamic mode),
user can get new settings by pressing the Release and then the Renew button. For Static
configuration, however, these two buttons are grayed out since user will enter these
addresses by using information provided by the ISP.
IP address: Enter the information provided by your ISP in case of Static configuration.
Subnet Mask: Enter the information provided by your ISP in case of Static configuration.
Gateway: Enter the information provided by your ISP in case of Static configuration.
- 20 -