User's Manual

and IPCONFIG /RENEW to renew IP addresses. For a list of the IPCONFIG commands,

type in IPCONFIG /? .

PING.EXE

Ping is used to verify that a computer is active and available. Users can ping a specific

destination domain name or just the IP address.

Example:

For example, to find the server 168.95.192.1, type the following command at the MS-DOS

prompt and then press “Enter”:

C:\>ping 168.95.192.1

PING can be executed in Windows as shown below:

1. Go to the Start menu.

2. Click Run.

3. Type ping 168.95.192.1 and click OK.

4. The server (IP address) is online if the following message appears.

Reply from 192.168.0.1: bytes=32 time=3ms TTL=100

5. The destination device is not reachable if the following message appears.

Reply from 192.168.0.1: Destination host unreachable

Request timed out.

ISP Connectivity Checkup

Issue a PING command to the IP address of your ISP’s Gateway or DNS server.

Note: If the global port was set to obtain configuration automatically, you need to check

Gateway and DNS server information under “Global Port” via the Windows GUI setup

program.

For Example:

From the GUI setup program, if the DNS server address is 203.66.81.254, at C:\> prompt,

enter Ping 203.66.81.254. If successful, you can reach your ISP server.

If unsuccessful, you may have trouble connecting to your ISP, please verify that the product

is properly configured to connect to your ISP. Also verify that your Cable/DSL modem and

the line are functioning properly.

Internet Connectivity Checkup

PING to an IP address or domain name on Internet.

- 53 -