User's Manual

CHANGING PASSWORD
The device has no password at default. It is recommended that you change the default
passwords to ensure that someone cannot adjust the device’s settings.
From GUI
1. Start this device by running setup.exe as described in the chapter titled “Configuration”.
2. Check “Change Administrator’s Password.
3. Enter the desired new password in “New Password” and enter the new password again in
the “Confirm New Password” field and then click “Save” at the bottom.
Figure 18
From Terminal
Refer to the previous section titled “Configuration in Terminal Program” for terminal
emulation. After seeing the following command prompt, follow the instructions in italic fonts
to setup the new password. Please note that passwords are case sensitive.
command>passwd
Please type old password: **** Type in old password and press
<Enter>
- 43 -