User's Manual

TCP/UDP Port Filter: Filtering by the port number. You can set filter for a single port or a
range of ports.
• TCP port: filtering according to the Connection-Based Application Service on the
remote server using the port number.
• UDP port: filtering according to the Connectionless Application Service on the remote
server using the port number.
ADD: Add the entry in the Filter List.
RESET: Clear the entries.
When you have finished setting the filters, the added filters will appear on the Filter List. To
remove a filter, select the Filter number by clicking the down arrow  next to “Item”, and
click Delete. Note: You can input up to six filters in this device and you can only set each
filter type to either filter or forward. For example, you can’t set one IP address to filter and
set another IP address to forward. You must set them both to either filter or forward.
However, you can set to filter an “Adapter Address” and set to forward an “IP address”.
Advanced Settings
You can set static routes to manually administrate the network topology/traffic when the
dynamic route is not effective enough.
Select “Static Route #1” or “Static Route #2”, enter the settings, and click “SAVE” to save
settings. Click “RESET” to clear all entries.
- 24 -