User guide

18
Programming the Base Unit
Programming Telephone Numbers
If you choose to only contact 911 - and not a custom
telephone number - skip these next steps (and go to
page 16) - and make sure your slide switch on the back
of the Base unit is set to “911 only”.
Programming Notes
• As you program the system using your telephone, you
will hear the base unit speak each number as it is
pushed.
• Dial slowly and listen for each number to be an-
nounced. If you did not hear the announcement - the
number was not recorded.
• The System can learn telephone numbers up to 32 dig-
its long. You do not have to program all 4 numbers
• To add a pause in your number sequence......insert a
“
*
” for a 1 second pause. Insert “
**
” a 2 second
pause.
• Remember to program a 1 before any long distance
numbers.
• Remember to program any AREA CODE numbers if
needed.
• Remember to program any PREFIX NUMBERS (like 9 to
get an outside line) if needed.
• If at any time a new number is programmed into the sys-
tem, all old numbers will be erased.