User's Manual

Chapter 1 Siemens 9751 9006i DTMF Integration
Testing the Integration
1-14
Siemens 9751 9006i DTMF Integration Guide
OL-1747-02
Step 6 Confirm that, after the number of rings that the phone system is set to wait, the
call is forwarded to Cisco Unity and that you hear the greeting for Example
Subscriber. Hearing the greeting means that the phone system forwarded the
unanswered call and the call-forward information to Cisco Unity, which correctly
interpreted the information.
Step 7 On the Status Monitor, note the port that handles this call.
Step 8 Leave a message for Example Subscriber and hang up Phone 2.
Step 9 On the Status Monitor, confirm that the state of the port handling the call changes
to “Idle.” This state means that the port was successfully released when the call
ended.
Step 10 Confirm that the MWI on Phone 1 is activated. The activated MWI means that the
phone system and Cisco Unity are successfully integrated for turning on MWIs.
To test an internal call with release transfer
Step 1 From Phone 1, enter the internal pilot number for Cisco Unity.
Step 2 When asked for your password, enter 12345. Hearing the request for your
password means that the phone system sent the necessary call information to
Cisco Unity, which correctly interpreted the information.
Step 3 Confirm that you hear the recorded voice name for Example Subscriber. Hearing
the voice name means that Cisco Unity correctly identified the subscriber by the
extension.
Step 4 When asked whether you want to listen to your messages, press 1.
Step 5 After listening to the message, press 3 to delete the message.
Step 6 Confirm that the MWI on Phone 1 is deactivated. The deactivated MWI means
that the phone system and Cisco Unity are successfully integrated for turning off
MWIs.
Step 7 Hang up Phone 1.
Step 8 On the Status Monitor, confirm that the state of the port handling the call changes
to “Idle.” This state means that the port was successfully released when the call
ended.