User's Manual

Chapter 1 Siemens 9751 9006i DTMF Integration
Programming the Phone System
1-8
Siemens 9751 9006i DTMF Integration Guide
OL-1747-02
Make sure that the phone system sends calls only to Cisco Unity voice ports that
are set to Answer Calls on the System > Ports page in the Cisco Unity
Administrator. Calls sent to a voice messaging port not set to Answer Calls cannot
be answered by Cisco Unity and may cause other problems.
Step 7 Go to menu 1.1 - System Parameters and set the following parameters.
Table 1-4 ADDHUNT Parameter Settings
Parameter Required Setting
TYPE VCE
AC <the pilot number of the hunt group>
DPLN 0
STNP <the extension numbers of the answering voice messaging
ports>
NAME CISCO UNITY VOICE MESSAGING
CQMAX 10 (the number of subscribers that may be queued when all
the ports are busy)
FNA N
STYPE CIR (circular hunt group)
Table 1-5 Menu 1.1 - System Parameter Settings
Parameter Required Setting
Type of PBX VPMOD is on 2 - Other
Number of digits in an
extension (Used for MWI)
(leave field blank)
Sender ID used for Telephone
Answering Messages
2 - Calling Party if Known
ACP Used for Integration N