Instructions

8 Troubleshooting

If an automatic power failure occurs, open the front cover shown

below and use the lever to reset the tripped circuit breaker.

If this is unsuccessful and the residual current circuit breaker trips

again, there is probably a fault that can only be eliminated by

trained and qualiﬁed personnel.

Please note that the warranty will not apply if unauthorized repairs

are carried out. ABL-SURSUM shall not be liable for any conse-

quential damages or losses.

TROUBLESHOOTING

Wallbox

Fault Possible cause Remedy

Charging cycle does not start even

though the LED



is ﬂashing

Charging cable not inserted correctly

at the vehicle or at the charging box

Check secure connection of the plug at the

vehicle and, if necessary, at the charging box

(disconnect, reconnect the plug)

Charging cycle does not start even

though the LED



is not illuminated

· Residual current circuit breaker of

the charging box has tripped

· Upstream fuse in the house fuse box

has blown

· Disconnect the plug at the vehicle, open

the cover of the charging box, reset the

residual circuit breaker; reconnect the plug

· Check the fuses of the upstream power

supply (usually in the house fuse box)

No LED display · LED defective

· LED wire faulty

· Contact the Customer Service Department

LED



and

LED



ﬂash alternately

Fault Disconnect the plug from the vehicle and

repeat charging. If the problem occurs again,

contact the Customer Service Department