User manual
EVCC – Installation and User Guide
Page 14
Dok. Nr. 03 0009 01 D
Function PCModule ModulePC Parameter xxxx
Set PWM
(Charging current)
!n 12 xxxx >n 12 0000 6A
0001 10A
0002 13A
0003 16A
0004 20A
0005 30A
0006 32A
0007 63A
0008 70A
0009 80A
0010 Default charging current
0080..0970 direct 8%...97%
0999 charging not allowed
PWM enabled M !n 13 >n 13
PWM disabled M !n 14 >n 14
Set default PWM
(default charging current)
M !n 15 xxxx >n 15 0000 6A
0001 10A
0002 13A
0003 16A
0004 20A
0005 30A
0006 32A
0007 63A
0008 70A
0009 80A
Set marker “ventilation” M !n 16 111x >n 16
Get marker “ventilation” !n 17 >n 17 000x
0 ventilation connected
1 ventilation not connected
Set address of module M !n 22 111x >n 22
Get address of module !n 23 >n 23 000x
1…8 Address 1…8
0 Broadcast/Default
Load factory settings and
reset
M !n 24 1111 >n 01 Vx.y Vx.y Firmware Rev.
Stop charging -or-
Leave MANUAL
!n 25 >n 25
Get default PWM (default
charging current)
!n 26 >n 26 xxxx Default PWM in 0.1%-steps
I
DEFAULT
=
PWM⋅0.6A resp. (PWM-64)⋅2.5A
Set bBreakCharge !n 27 >n 27
Clear bBreakCharge !n 28 >n 28
bBreakCharge=1⇒ charging procedure
halted at B1
Get bBreakCharge !n 29 >n 29 xxxx 0000 bBreakCharge=0
0001 bBreakCharge=1
Switch to A’ !n 30 >n 30
Leave A’ !n 31 >n 31 Switch to A