User Guide

3-16 Chapter3
SE6
Power On Function:
This item allows you to select which way you want your system to power on. Seven items are available:
Password
)
Hot Key
)
Mouse Left
)
Mouse Right
)
Any Key
)
Button Only
)
Keyboard 98.
Default setting is
Button Only.
Note: The mouse wake up function can only be used with the PS/2 mouse, not with a mouse that uses
the COM port and USB connection.
Mouse Left
(
Mouse Right
) means you need to double click the
mouse
left
(
right
) button, for the computer to power on. You also need to note the compatibility issue
with your PS/2 mouse. Some PS/2 mice cannot wake up the system because of compatibility problems.
Also, if the specs of your keyboard are too old, it may fail to power on.
✏
✏✏
✏
KB Power ON Password:
This option allows you to set a password required in order to Power ON your computer. You will be
asked to enter your password and then to confirm it. Do not forget your password. Should you forget
your password, you will have to open your computer case, clear the CMOS and reset all parameters
again in order to be able to utilize this function.
✏
✏✏
✏
Hot Key Power On:
There are twelve options are available, <Ctrl>-<F1> to <Ctrl>-<F12>. You can select this item and
using the <Ctrl> plus the one of each function key (<F1> to <F12>) to power on the computer. The
default setting is
<Ctrl>-<F1>
.
Onboard FDC Controller:
Two options are available: Enabled and Disabled. The default setting is
Enabled
. You can enable or
disable the onboard FDD controller.
Onboard Serial Port 1:
This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available: Disabled
)
3F8/IRQ4
)
2F8/IRQ3
)
3E8/IRQ4
)
2E8/IRQ3
)
AUTO. The default setting is
3F8/IRQ4
.
Onboard Serial Port 2:
This is used to specify the I/O address and IRQ of Serial Port 1. Six options are available: Disabled
)
3F8/IRQ4
)
2F8/IRQ3
)
3E8/IRQ4
)
2E8/IRQ3
)
AUTO. The default setting is
2F8/IRQ3
.
✏
✏✏
✏
Onboard IR Function:
Three options are available: IrDA (HPSIR) mode
)
ASK IR (Amplitude Shift Keyed IR) mode
)
Disabled. The default setting is
Disabled.
✏
✏✏
✏
RxD , TxD Active:
Four options are available: Hi, Hi
)
Hi, Lo
)
Lo, Hi
)
Lo, Lo. The default setting is
Hi, Lo
. Set IR
transmission/reception polarity as High or Low.
✏
✏✏
✏
IR Transmission Delay:
Two options are available: Enabled and Disabled. The default setting is
Enabled
. Set IR transmission
delays 4 character-time (40 bit-time) when SIR is changed from RX mode to TX mode.
✏
✏✏
✏
UR2 Duplex Mode: