Installation guide

31
To add a Nessus Perimeter Service scanner to SecurityCenter, a valid and active Nessus Perimeter Service subscription
must be used. In SecurityCenter, select the “Resources” tab, “Nessus Scanners”, and then “Add”:
Enter a name (mandatory) and description (optional) for the Nessus Perimeter Service scanner to be used with
SecurityCenter. Enter the web address used for the browser-based version of the Nessus Perimeter Service as “Host”,
with the “Port” specified as 443 (HTTPS). Enter a valid Nessus Perimeter Service username and password for
authentication and select the zone(s) within SecurityCenter that will use the Nessus Perimeter Service scanner. When
finished, click “Submit” to add the authorized Nessus Perimeter Service scanner to SecurityCenter. If successful, the
Nessus Perimeter Service scanner will be listed under “Nessus Scanners” with a status of “Working”:
Note that existing scan reports from the Nessus Perimeter Service are not automatically made available through
SecurityCenter, but they can be manually downloaded and imported into SecurityCenter by users with permissions to do
so.