User Guide

Introducing the BIOS
User’s Manual
3-31
When set to Disabled, activity will neither prevent the system from going into a power management mode
nor awaken it. Each item has two options: Enabled ) Disabled.
"
IRQ3 (COM 2): The default setting is Enabled.
"
IRQ4 (COM 1): The default setting is Enabled.
"
IRQ5 (LPT 2): The default setting is Enabled.
"
IRQ6 (Floppy Disk): The default setting is Enabled.
"
IRQ7 (LPT 1): The default setting is Enabled.
"
IRQ8 (RTC Alarm): The default setting is Disabled.
"
IRQ9 (IRQ2 Redir): The default setting is Disabled.
"
IRQ10 (Reserved): The default setting is Disabled.
"
IRQ11 (Reserved): The default setting is Disabled.
"
IRQ12 (PS/ 2 Mouse): The default setting is Enabled.
"
IRQ13 (Coprocessor): The default setting is Enabled.
"
IRQ14 (Hard Disk): The default setting is Enabled.
"
IRQ15 (Reserved): The default setting is Disabled.
3-7. PnP/PCI Configurations Setup Menu
In this menu, you can change the INT# and IRQ# of the PCI bus and other hardware settings.
Figure 3-8A. PnP/PCI Configurations Setup Menu
PNP OS Installed:
Two items available: No or Yes. The default setting is No. If this set to No, device resources are assigned
by the BIOS. If this set to Yes, the OS assigns device resources.