User Guide

Chapter 3
KR7A/KR7A-RAID
3-18
AGP Fast Write:
Two options are available: Disabled or Enabled. The default setting is Disabled. If your AGP adapter can
support this function, then you can choose Enabled. Otherwise, choose Disabled.
AGP Master 1 WS Write:
Two options are available: Disabled or Enabled. The default setting is Disabled. This implements a single
delay when writing to the AGP Bus. When you set it to Enabled, two-wait states are used by the system,
allowing for greater stability.
AGP Master 1 WS Read:
Two options are available: Disabled or Enabled. The default setting is Disabled. This implements a single
delay when reading to the AGP Bus. When you set it to Enabled, two-wait states are used by the system,
allowing for greater stability.
CPU & PCI Bus Control:
This item can let you sets several items concerning the PCI parameters. If you do not understand what
each item does, please keep the default settings as well. Wrong settings will cause system unstablity.
Figure 3-5D. CPU & PCI Bus Control Screen
PCI1 Master 0 WS Write:
Two options are available: Enabled or Disabled. The default setting is Enabled. When Enabled, writes to
the PCI1 bus are executed with zero wait state (immediately) when PCI1 bus is ready to receive data. If it
is set to Disabled, the system will wait one state before data is written to the PCI1 bus.
PCI2 Master 0 WS Write:
Two options are available: Enabled or Disabled. The default setting is Enabled. When Enabled, writes to
the PCI2 bus are executed with zero wait state (immediately) when PCI2 bus is ready to receive data. If
set to Disabled, the system will wait one state before data is written to the PCI2 bus.