User`s manual

3-18 Chapter 3
 Master/Slave Drive PIO Mode
Six options are available: Auto  Mode 0  Mode 1  Mode 2  Mode 3  Mode 4. The five IDE
PIO (Programmed Input/Output) items let you set a PIO mode (0-4) for each of the four IDE devices that
the onboard IDE interface supports. Modes 0 through 4 provide successively increased performance. In
Auto mode (default setting), the system automatically determines the best mode for each device.
 Master/Slave Drive Ultra DMA
Two options are available: Auto and Disabled. The default setting is Auto. Ultra DMA is a DMA data
transfer protocol that utilizes ATA commands and the ATA bus to allow DMA commands to transfer data
at a maximum burst rate of 133 MB/sec.
Auto: If your hard drive and your system software both support Ultra DMA, select Auto to enable BIOS
support.
Disabled: If you encounter a problem in using Ultra DMA devices, you can try to disable this item.
OnChip IDE-2 Controller:
The description is same as the OnChip IDE-1 Controller.
 Back to Integrated Peripherals Setup Menu:
OnChip PCI Device(s):
Press <Enter> key to enter the OnChip PCI Device menu.
OnChip Audio Controller:
This option enables or disables the audio controller.
OnChip LAN Controller:
This option enables or disables the LAN controller.
OnChip LAN Boot ROM:
This item enables or disables the Boot ROM on LAN controller.
KD7 Series