User`s manual

Introduction 1-3
 Supports Wake On LAN, Modem, but your ATX power supply 5V standby power must be
able to provide at least a 720mA current capacity. Otherwise, the functions may not work
normally.
 For KD7-RAID: PCI slot 5 shares IRQ signals with the HPT 372 IDE controller (supports
Ultra ATA/133). The driver for HPT 372 IDE controller supports IRQ sharing with other
PCI devices. But if you install a PCI card that doesn’t allow IRQ sharing with other devices
into PCI slot 5, you may encounter some problems. Furthermore, if your Operating System
doesn’t allow peripheral devices to share IRQ signals with each other, such as Windows® NT
for example, you can’t install a PCI card into PCI slot 5.
 For KD7-RAID: HPT 372 IDE controller is designed to support high-speed and high
performance mass storage devices. Do not connect non-disk devices in ATA/ATAPI interfaces,
such as CD-ROM, to HPT 372 IDE connector (IDE3 & IDE4).
 This motherboard supports the standard bus speeds of 66MHz/100MHz/133MHz/166MHz
that are used by specific PCI, processor and chipset specifications. Exceeding these standard
bus speeds is not guaranteed due to the specific component specifications.
 The Serial ATA controller only supports Ultra DMA/ATA100 or higher hard drive. Do not
use hard drives under this specification, or it won’t work.
 Specifications and information contained in this manual are subject to change without notice.
User’s Manual