User Guide

Appendix A
A-6
Some jumpers are reserved for future
functions or are not to be adjusted in normal operation. Adjust them
according to the following recommendations.
CCMOS : Put jumper on pin 1 and pin 2.
JC1 : OFF (don’t need to use any jumper).
Parameters and CPU settings After you have
followed the steps described above and completed the installation, when
you power the computer on, you will see the following message displayed:
TO ENTER SETUP BEFORE BOOT PRESS CTRL-ALT-ESC OR
DEL KEY
Press immediately Del key to enter BIOS Setup. Select Load Setup
Defaults, than enter CPU Soft Menu to set CPU parameters.
Adjusting other jumpers:
BIOS Setup: