User`s manual

BIOS Setting Utility 3-5
User’s Manual
3-6. Create Spare Disk
This item allows you to select the disk to be used as a spare for a Mirror Disk Array.
3-7. Remove Spare Disk
This item allows you to remove the spare disk from a Mirror Disk Array.
3-8. Set Drive Mode
This item allows you to select the drive transfer mode for the hard disk(s) attached to this
IDE RAID controller card.
Use the up/down arrow to select the menu option to “Set Drive Mode” and press <Enter>. In
the Channel Status, select the channel you would like to set and press the <Enter> key. There
will be an asterisk mark in the parentheses indicating that the channel selection has been
done. Choose the mode from the pop-up menu. You can choose from PIO 0 ~ 4, MW DMA
0 ~ 2, and UDMA 0 ~ 5.