User`s manual

MAG
MA
33
on the OK button to close the new dialog.
4. The properties dialog should close and the original “Safely
Remove Hardware” dialog should remain.
Click on the Stop button of the dialog.
5. A dialog with the title “Stop a Hardware device” should appear.
This device is used to confirm that the user wishes to stop this
device.
Click on the OK button of the new dialog.
6. After a brief period a pop up will appear telling the user that the
device may be removed safely, and the device will be removed
from the list of the original dialog.
Press the Attention button that corresponds to the slot
where the device is located.
7. An LED, labeled SLOT X Attention (where X corresponds to
the slot number) will begin to flash. The LED is located on the
vertical backplane towards the back edge of the chassis as
shown below:
Note:
If, by mis
take, you’ve pressed the button corresponding
to the wrong slot, then press it again within 5 seconds and the
hot plug request will be ignored. Otherwise continue to step 8.
中国总代理 长沙鹏翔
全国服务热线：4006-010-842
长沙鹏翔电子科技有限公司
地址：长沙高新区文轩路27号麓谷企业广场A4栋507
网址：http://www.ndttech.net