User manual

During the qualification run the lap times will be announced. At the last 10 seconds of the race you will be told
to finish your last lap. When you are finished your result will be announced and you can bring your car back to
the pit lane and abort Practice mode.
If you have set Replay ON (in Other game options) you can save the replay file that was recorded.
Start Race mode
When Normal or Reversed mode is selected in Race options you will see the Start race button at the bottom
right part of your screen. The start procedure is the same as in qualify mode, but the cars will now be placed
on the starting grid on the track. The clock will be started at the start signal. The time until the first passing of
the Start/Finish line will be recorded as lap 0 and will not count for the fastest or slowest lap analysis.
If you have set Replay ON (in Other game options) you can save the replay file that was recorded.
Pit stop dialog
When you are in the pit lane in the refuel and repair area and the speed is under 20 km/h the pit stop dialog
will be displayed. Here you can make quick adjustments to the car. You cannot change components in the pit
stop dialog, for that you must return to the pit table and then back to the work bench.
It may be that not all the set up options can be adjusted. This depends on your set up level, you can upgrade
to a higher level, see for more information the Set up dialogs chapter. The pit stop dialog will disappear
automatically when you drive away from the pit lane, or click on the GO button.
Nitro only:
You will be called to refuel when there is 10cc left in your tank, and a second time when 5cc is left.
When running out of fuel on the track you must hit the spacebar to bring the car back to the pit lane. Click on
the Refuel button to fill up again, and next click on the Start engine button which will start the engine. You can
then continue to race.
After adjusting a set up parameter you must always click on the Apply button else the change will not take
effect. This also applies to the repair, refuel and change tires sections. When the Apply button is clicked the pit
stop dialog is temporarily disabled and you cannot perform other adjustments.
Each of the adjustment or repair buttons requires time, like in the real world. Having to adjust your engine will
cost you 2 seconds, changing your tires may take 8 seconds or so.
Any changes made to the setup of your car will remain active until you change the chassis. If you want to save
the setup you must go to the workbench and click on the Save setup button.