User manual

Practice – Time trial - Events – Multi-player (general part)
This chapter explains the general part of the actual racing part of VRC PRO and applies to the practice, time
trial, race and multiplayer modes or racing.
Race information displays
At the top left you will see the race standings with the actual positions and lap and time differences. On the
top right the lap time information is displayed, showing the last 10 laps and your best lap of that session. On
the right bottom there is information about the engine or motor, rpm and speed. The maximum revs and the
top speed during the session is displayed.
Zooming
VRC Pro has dynamic zooming that can be adjusted. Zooming has 2 stages:
- static near zoom
- dynamic far zoom
First you set your near zoom with + and -. Near zoom does not change as long as the car is within the near
zoom range (this is static and pre-set). Set the near zoom when the car is nearby, for instance on the track
right in front of the rostrum.
Dynamic zooming starts when the car leaves the near zoom range. You can place the car anywhere on the
track, for instance the furthest part on the track and adjust the amount of zoom you want for that point. The
dynamic zooming will start linear zooming from the end of the near zoom range till that point. With + you
increase the dynamic zooming, with - you decrease the dynamic zooming. The system automatically detects if
your car is inside or outside the near zoom range and it will therefore adjust the near or the far zoom when
using the + and – keys.
Warm up
When Normal or Reversed mode is selected in Race options you will see Warm up at the bottom right part of
your screen. The warm up will last until you hit the Start Qualify or Start Race button. During the Warm up the
lap timing is active.
Note: You must realize that during warm up you will consume fuel or battery power and wear tires down.
Therefore you should refuel or change batteries, and perhaps even put fresh tires on when you are in the pit
lane during the start procedure for a qualify or final session.
Start Qualify mode
When Normal or Reversed mode is selected in Race options you will see the Start qualify button at the bottom
right part of your screen. When you click on Start qualify button the countdown starts at 30 seconds. At 20
seconds you are asked to return your car to the pit lane. You should refuel or change battery and get fresh
tires for your race.
At 10 seconds your car is placed at the staggered start position in the pit lane and kept in the air until 1 second
before the start. You can throttle the car during the last 10 seconds. At I second you must your car in the start
position until you hear the start signal. If you start early you will receive a 1 lap penalty. The clock is started at
the first passing of the Start/Finish line.