User`s manual

3-16 Chapter 3
3.8. Install the IDE Hard Drive
The hard-drive holder of this system is capable of installing two 3.5” hard drives. The
diagrams illustrated here are using one IDE hard drive for example.
Don’t forget the Master/Slave configuration when installing two hard drives.
If you want to install ATA and SATA hard drive together, make sure to install the
SATA hard drive at the upper layer.
Install one IDE hard drive into the
bay. Fasten the hard drive to its
holder.
Connect the signal cable to the hard
drive.
Pay attention to the Master/Slave
configuration no matter installing
one or two optical drives.
AB-2003 DigiDice