User`s manual

Hardware Setup 3-3
3-3. Install System Memory
This motherboard provides two 184-pin DDR DIMM sites for memory expansion available
from minimum memory size of 64MB to maximum memory size of 2GB DDR SDRAM.
Table 2-1. Valid Memory Configurations
Bank Memory Module Total Memory
Bank 0, 1 (DIMM1) 64, 128, 256, 512MB, 1GB 64MB ~ 1GB
Bank 2, 3 (DIMM2) 64, 128, 256, 512MB, 1GB 64MB ~ 1GB
Total System Memory
64MB ~ 2GB
ATTENTION: Static electricity can damage the electronic components of the computer or
optional boards. Before starting these procedures, ensure that you are discharged of static
electricity by touching a grounded metal object briefly.
1. Power off the computer and disconnect the AC power cord.
2. Locate the DDR DIMM slot.
3. Push both ejector tabs of the DDR
DIMM slot outward.
4. Insert the memory module into the DDR
DIMM slot. Note how the module is
keyed to the slot. This insures the
memory module will be plugged into
the slot in one way only.
5. Firmly press the memory module into
the DDR DIMM slot until both ejector tabs snap into places.
Figure 2-4. Memory module installation
User’s Manual