User Guide

BIOS Setup 3-13
Suspend Mode = 1 Min.
HDD Power Down = 1 Min.
Suspend Mode/HDD Power Down:
These two items will be enable to change setting when item Power Management is set to User Define,
theses two item will also changes as table 3-1 below.
Table 3-1: Power Management Settings
Power Management Settings
Items
User Define Min Saving Max Saving
Suspend Mode
Disabled  1 Min  2 Min  4 Min  8 Min
 12 Min  20 Min  30 Min  40 Min  1
Hour. The default setting is Disabled.
1 Hour 1 Min
HDD Power Down
Disabled  1 Min  2 Min  3 Min  4 Min
 5 Min  6 Min  7 Min  8 Min  9 Hour
 10 Min  11 Min  12 Min  13 Min  14
Min  15 Min. The default setting is Disabled.
15 Min 1 Min
Video Off Method:
Three video off methods are available: “Blank Screen”, “V/H SYNC + Blank” and “DPMS”. The default
is “V/H SYNC+Blank”.
If this setting does not shut off the screen, select “Blank Screen”. If your monitor and video card support
DMPS standard, select “DPMS”.
• Blank Screen: This option only writes blanks to the video buffer.
• V/H SYNC + Blank: This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
• DPMS: Initial display power management signaling.
Video Off In Suspend:
Two options are available: Yes or No. The default setting is Yes. This item determines the manner in
which the monitor is blanked.
Suspend Type:
Two options are available: Stop Grant and PwrOn Suspend. The default setting is Stop Grant.
Modem Use IRQ:
You can specify the IRQ for modem use. Eight options are available: NA  3  4  5  7  9  10
 11. The default setting is NA.
Soft-off by PWR-BTTN:
Two options are available: Instant-off and Delay 4 Sec.. The default setting is Instant-off. Pressing the
power button for more than four seconds forces the system to enter the Soft-Off state when the system has
“hung”.
User’s Manual