User`s manual

3-20 Chapter 3
# IDE Function Setup:
Click <Enter> key to enter its submenu:
Phoenix – Award WorkstationBIOS CMOS Setup Utility
IDE F tup uction Se
Onboard IDE-1 Controller Enabled Item Help
Onboard IDE-2 Controller Enabled
IDE DMA transfer access Enabled
Serial-ATA 1 Enabled
- SATA DMA transfer Enabled
Serial-ATA 2 Enabled
- SATA 2 DMA transfer Enabled
IDE Prefetch Mode Enabled
↑↓:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Onboard IDE-1 Controller / Onboard IDE-2 Controller:
This item allows you to enable or disable the primary (IDE1) and secondary (IDE2) IDE controller. Select
[Disabled] if you want to add a different hard drive controller.
IDE DMA transfer access:
This item selects the DMA mode for devices connected through IDE channels.
Serial-ATA 1/Serial ATA 2:
This item enables or disables the on-chip SATA controller.
SATA DMA transfer/SATA 2 DMA transfer:
This item selects the DMA mode for devices connected through SATA channels.
IDE Prefetch Mode:
Two options are available: Disabled or Enabled. The default setting is Enabled. The onboard IDE drive
interfaces support IDE prefetching for faster drive accesses. If you install a primary and/or secondary
add-in IDE interface, set this field to Disabled if the interface does not support prefetching.
Fatal1ty AN8 SLI