User Guide
Table Of Contents
- Introduction
- Hardware Setup
- BIOS Setup
- Driver & Utility CD
- Intel Chipset Software Installation Utility
- Intel Matrix Storage Technology Driver
- Realtek Audio Driver
- Realtek LAN Driver
- Silicon Image 3132 SATA Driver
- JMicron SATA Driver
- USB 2.0 Driver
- ABIT μGuru Utility
- Intel SATA RAID Driver Disk Maker
- Sil3132 SATA RAID Driver Disk Maker
- JMicron SATA RAID Driver Disk Maker
- Appendix
Power Button Function
This item selects the method of powering off your system:
[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system.
This will prevent the system from powering off in case you accidentally hit or pushed the power
button.
[Instant-Off]: Pressing and then releasing the power button at once will immediately power
off the system.
Wake Up by PME# of PCI
When set to [Enabled], access through the add-on PCI card can remotely wake up the system
that was in Soft-Off condition. The PCI card must support the wake up function.
Wake Up by Onboard LAN1
When set to [Enabled], access through the onboard LAN1 port can remotely wake up the
system that was in Soft-Off condition.
Wake Up by Onboard LAN2 (AB9 Pro)
When set to [Enabled], access through the onboard LAN2 port can remotely wake up the
system that was in Soft-Off condition.
Resume by Alarm
When set to [Enabled], you can set the date and time you would like the Soft-Off PC to
power-on in the “Date (of Month) Alarm” and “Time (hh:mm:ss) Alarm” items. However,
if the system is being accessed by incoming calls or the network (Resume On Ring/LAN) prior to
the date and time set in these items, the system will give priority to the incoming calls or
network instead.
- Date (of Month) Alarm
[0]: This option power-on the system everyday according to the time set in the “Time
(hh:mm:ss) Alarm” item.
[1-31]: This option selects a date you would like the system to power-on. The system will
power-on on the date set, and the time set in the “Time (hh:mm:ss) Alarm” item.
- Time (hh:mm:ss) Alarm
This item sets the time you would like the system to power-on.
POWER ON Function
This item selects the way you want your system to power on.
[Password]: Use a password to power on the system, select this option then press <Enter>.
Enter your password. You can enter up to 5 characters. Type in exactly the same password to
confirm, and then press <Enter>.
[Hot KEY]: Use any of the function keys between <F1> to <F12> to power on the system.
[Mouse Left]: Double click the mouse left button to power on the system.
3-22 AB9 Pro, AB9