User Guide
Table Of Contents
- Introduction
- Hardware Setup
- BIOS Setup
- Driver & Utility CD
- Intel Chipset Software Installation Utility
- Intel Matrix Storage Technology Driver
- Realtek Audio Driver
- Realtek LAN Driver
- Silicon Image 3132 SATA Driver
- JMicron SATA Driver
- USB 2.0 Driver
- ABIT μGuru Utility
- Intel SATA RAID Driver Disk Maker
- Sil3132 SATA RAID Driver Disk Maker
- JMicron SATA RAID Driver Disk Maker
- Appendix
Hardware Setup
AB9 Pro, AB9 2-7
2.4.2 Front Panel Switches & Indicators Headers
This header is used for connecting switches and LED indicators on the chassis front panel.
Watch the power LED pin position and orientation. The mark “+” align to the pin in the figure
below stands for positive polarity for the LED connection. Please pay attention when connecting
these headers. A wrong orientation will only cause the LED not lighting, but a wrong connection
of the switches could cause system malfunction.
• HLED (Pin 1, 3):
Connects to the HDD LED cable of chassis front panel.
• RST (Pin 5, 7):
Connects to the Reset Switch cable of chassis front panel.
• SPKR (Pin 13, 15, 17, 19):
Connects to the System Speaker cable of chassis.
• SLED (Pin 2, 4):
Connects to the Suspend LED cable (if there is one) of chassis front panel.
• PWR (Pin 6, 8):
Connects to the Power Switch cable of chassis front panel.
• PLED (Pin 16, 18, 20):
Connects to the Power LED cable of chassis front panel.