Specifications

 POWER SUPPORT

The Wildcat Realizm 800 requires the following:

 A 16-lane PCI Express slot that conforms to the PCI Express x16 Graphics 150W-ATX Specification

1.0. Detailed information on the PCI Special Interest Group (PCI -SIG) specification can be found

here:

http://www.pcisig.com/specifications/pciexpress/graphics/

 A six-pin auxiliary power connection in to the power supply. This connection should be available in a

computer system designed to be PCI Express x16 Graphics 150W-ATX Specification 1.0 compliant.

The connector should be black.

 A 500 W (recommended minimum) power supply. Since the Wildcat Realizm 800 can use a

maximum of 150 watts under full load conditions, it requires an additional High-end power connector

from the system power supply.

 SUFFICIENT PHYSICAL SPACE

The Wildcat Realizm 800 is a full length, double width add-in card that adheres to the industry approved PCI

Express™ x16 Graphics 150W-ATX Specification 1.0. This specification states there can be no interference

with the physical space in which the graphics card resides by components mounted on the motherboard or

system chassis, such as:

• Disk drive brackets

• Disk drive cables

• Capacitors

• Serial ATA connectors

In some cases, it may be necessary to use another connector, reroute cables, or purchase right-angle

cables for Serial ATA devices.

Below are specific width, height, and length restrictions for the Wildcat Realizm 800 and as defined in the

PCI Express x16 Graphics 150W-ATX Specification 1.0.

3Dlabs