Operation Manual

37
2.6 Recording IR Channels from another Transmitter
Make sure the batteries in both transmitters are fully charged. Do not use the transmitters in
intense light (e.g., sunlight) when programming.
Place the two transmitters on a table with the original transmitter directed towards the rear
of your Control Medi, see picture.
1. First press
---
and then simultaneously press
1
for 2 seconds.
When you release the buttons the “Setting” alert sounds and the
indication lamp on button 1 flashes.
2. Press
1
.
3. Choose the level where the channels are to be recorded with
---
.
4. Press the button
X
where the channel is to be recorded. The
indicator light for the selected button glows steadily and the
“Press” alert sounds.
5. Press and hold the corresponding button
Y
on the original
transmitter pressed. Release the button when the indicator light
for the selected button goes off and the “Release” alert sounds.
This may take up to 10 seconds. If the indicator light glows again
and the “Press” alert sounds, you should press the button one or
more times until the “Success” alert sounds.
If the “Error” alert sounds, the recording has failed. Try again
from step 4.
6. If the recording of the first button was successful, repeat steps 4
and 5 until all buttons are programmed.
7. Finish by pressing
---
for 2 seconds.
8. If the action is successful, the “Success” alert sounds. If
something goes wrong or takes too long, the “Error” alert sounds.
9. Now test your recorded functions on the device that is to be
controlled.
10. recorded functions on the device that is to be controlled.
Recording IR Channels
Press
---
+
1
2 sec
,
1
, choose the level with
---
, select button
X
, select button
Y
,
then continue or finish with
---
2 sec
Important! When just one level is used, the Level button automatically becomes the next
levels first button, see Table 1. It means that it is possible to record an IR channel on the
Level button, but only when just one level is being used.
Original
transmitter