Installation Guide

NOTE: paper and cardboard templates where
supplied are only to be used as a guide.
Using the actual sink ensures a more
accurate cutout.
Clean the boom of the countertop and the
top flange (or lip) of the sink with methylated
spirits. Then apply a bead of silicone to the
top edge of the bowl. Posion sink in place
then screw the bridge plate to the mber
border using the thumb screws to secure
the sink in correct posion.
Aach a mber border evenly around the
perimeter of the countertop cutout to
accommodate the size of the sink.
This should be epoxied/adhered to the
underside of the countertop.
Templates are supplied only as a guide. The physical use of the sink will ensure a more accurate cutout. Abey recommends that undermount sinks and routering of your solid
surface material should be installed by a professional installer for best results. Warranty is voided if epoxy or adhesive is used to secure the sink to the bench.
SCHOCK UNDERMOUNT SINK
INSTALLATION INSTRUCTIONS
1
SILICONE
SEALANT
3
TIMBER
BORDER
(MIN 25mm
THICK)
2
NOTE: paper and cardboard templates where
Aach a mber border evenly around the
(MIN 25mm
Flange
(or lip)
Timber
Border
Epoxy/
Adhesive
Clean the boom of the countertop and the