User's Guide

Industrial Tracker User Guide FW 1.6 V1.1
Page 9 of 13
11 July 2018
Restricted distribution
7.4 Parameters configuration
Any parameter can be remotely modified with a downlink LoRa message.
Such messages are built according to the following format:
Byte 0
Byte 1
Byte 2
Byte 3-6
0x0B
ACK
Parameter ID
New value [31-00]
The parameters identifier and the values are given in the following table
Parameter
ID
Unit
Range
Description
Position period
ul_period
0x00
second
60 - 86400
Period of position or activity messages in motion
tracking, start end tracking, activity mode or
permanent operating mode
Heartbeat period
lora_period
0x01
second
300 - 86400
Period of heartbeat messages (sent only in idle state)
Periodic position
report period *
periodic_pos_period
0x03
second
0,
900 - 604800
Period of the periodic position report.
When 0, no periodic position report is transmitted.
Geolocation sensor profile
Geoloc_sensor
0x05
none
0 - 9
Geolocation policy used in motion, start end or
permanent tracking operating mode
0- Wi-Fi only
1- GPS only
2- LP-GPS (AGPS/GPS)
3- Reserved (do not use)
4- Reserved (do not use)
5- Multimode (Wi-Fi + LP-GPS + GPS) (with reset to Wi-
Fi on timeout)
6-Wi-Fi-GPS only (Wi-Fi then GPS if Wi-Fi fails in one
geolocation cycle)
7- Wi-Fi-LPGPS only (Wi-Fi then LP-GPS if Wi-Fi fails in
one geolocation cycle)
8- Reserved (do not use)
9- Wi-Fi-LPGPS first, the Wi-Fi-GPS until timeout, then
back to Wi-Fi-LGPS
Oneshot geolocation
method
Geoloc_method
0x06
none
0-4
Geolocation policy used for periodic or on demand
positions:
0- Wi-Fi
1- GPS
2- XGPS (Low power GPS/GPS)
3- Wi-Fi-GPS only (Wi-Fi then GPS if Wi-Fi fails in one
geolocation cycle)
4- Wi-Fi-LPGPS only (Wi-Fi then LP-GPS if Wi-Fi fails in
one geolocation cycle)