User manual

17
Having the following components ready:
• Drill or rechargeable driller 2,5 mm
(for aluminium windows 3 mm)
• Phillips screwdriver (model PH1)
• Scissors or card board cutter
• pencil
• ladder according the height of the window
3.3. Tools
WIN-CONTROL WS 20.1
Warning: Important instruction on safe installation!
Follow all instructions! Incorrect installation may cause
serious injury!
Check after completing the installation the proper
functioning of the device, the control-LED, the acous-
tic close signal and the release cord!
18
WIN-CONTROL WS 20.1
3.4. Mounting instructions
3.4.1. Screw the brackets on window casement and
window frame
Close the window. First, put the window casement-bracket (C)
preferably in the middle at the window casement in such a way
that the noses (C1) rest on the frame. Mark the position of the
holes for the screws (fig. 1).
Pre-drill both holes and tighten the bracket (fig. 2, 3). After
take the window frame bracket (D) and put the sail (D1) at
the window casement bracket as in fig. 4. Mark with a
pencil both holes for the screws on the window frame (fig. 5).
Open the window and pre-drill the holes (fig. 6).
Now cut the fit-up-aid „sail“ (D1) carefully with scissors or a
knife (fig. 7). Afterwards screw the window frame bracket (D)
at the window frame.
Fig. 2: Pre-drilling the holes at
the window casement bracket (C)
Fig. 1: Putting the window casement
bracket (C) and marking the holes