User manual

33
Fig. 42: Inserted batteries
Fig. 41: Positive and negative
polarity of the batteries
WIN-CONTROL WS 20.1
A t t e n t i o n !
During the battery change
never touch the electronic
components!
4.8. Dismounting the window closers
First you have to close the window. Remove the clip with pull
cord (A1) (see 4.4, p. 28) and if available the male connector
(G1) of the rain sensor (G). Set the time slice to „0“. Before
the window closer is released from its bracket, the tension
spring has to be removed in order to avoid injuries.
Do not reverse positive and negative polarity (+/-) of the bat-
teries (fig. 41).! When the batteries are inserted, fit the two
housing parts together until they click into place.
Check after every opening of the housing the correct function
of the device especially the closing signal!
34
WIN-CONTROL WS 20.1
Attention! Do not place your fingers between device
and clip!
Pull the release cord (A2)! On doing so the clip with pull cord
(A1) is pulled out and releases the tension. Now remove the
window closer from the window casement bracket. The parts
can be separated by pressing in the recess with a screwdriver
or a similar pointed object (see fig. 43) and simultaneous re-
moving the window closer from right to left (fig. 44).
On the window frame and the window casement are small
holes (diameter about 2 mm) originating from drilling and
screws, which are less visible. We recommend the use of col-
oured coordinated and for windows suitable hard wax,
hard dough or putty.
Fig. 43: Separating the parts
Fig. 44: Removing the window closer
We wish you always fresh air and a good energy balance
using our hybrid-window closer
WIN-CONTROL WS 20.1 !