User manual

Using the simple version pass the rain

sensor cable outward (fig. 23). To do so

open the window as a whole as de-

scribed in 4.4 (p. 30).

Remove now the protective foil of the rain

sensor (fig. 24) and stick the sensor in such

a way that at the outer window frame that

rain drops can be reached (fig. 25).

Fig. 21/22:

Broking out the

protective cover

‘RS‘

Fig. 23: Passing the cable outward

Fig. 24: Removing the foil

Fig. 25: Fastening the rain sensor

WIN-CONTROL WS 20.1

Using the more elegant version the window closer has to be

opened. Proceed as described in section battery change

(4.7 / p. 31).

Take the upper housing of the window closer, pass the male

connector of the rain sensor inclusive cable through the open-

ing (fig. 26/27) and push it in the female connector (fig. 28).

Reconnect the upper housing of the window closer with the low-

er housing (fig. 29). Reinsert the bracket (fig. 30). Reconnect

the window closer with the window casement bracket (p.

20/21 / fig. 10/11).

Before sliding the clip on the window frame bracket again

fasten the cable with the rain sensor outside the window.

Fig. 28: Pushing the

male in the female con-

nector

Fig. 26/27: Passing the

male connector through the

opening