User manual

Fig. 10/11:

Connecting the window

closers with the window

casement bracket

Fig. 9: Pulling the clip inclusive pull cord (A1) and release cord

(A2) simultaneously

WIN-CONTROL WS 20.1

Fig. 12/13: Pushing the clip (A1) on the window frame bracket

3.4.3. Mounting the guide roller

The guide roller is mounted at the right side of the window. On

doing so, mark the position of holes again (fig. 14). Pre-drill an

hole (fig. 15) and screw the guide roller (E) on the right hand

side of the window closer on the window frame (fig. 16).

Pass the release cord (A2) around the guide roller and fit its

cover (F) (fig. 17/18). Cut it into the desired length (fig. 19),

connecting it with the cord end (B) doing a double knot (fig. 20).

The clip at the end of the pull cord (A1) is pushed now from

left to right on the window frame bracket until it clicks into

place (fig. 12/13).