User manual

Fig. 4: Putting the window casement-

bracket using the fit-up-aid (sail)

Fig. 5: Marking the position of screws

for the window frame bracket

Fig. 3: Screwing on window casement

Fig. 6: Pre-drilling the holes at the

window frame

Fig. 7: Cutting the fit-up-aid „sail“ (D1)

of the window frame bracket (D)

WIN-CONTROL WS 20.1

If you have bought the rain sensor (G) as an accessory, you

may fasten it now. Just follow the procedure as described in

3.5.

3.4.2. Fasten the window closer on the brackets

To connect the window closer including the clip (A, A1)

with the window frame bracket (D) you have to stretch

the spring mechanism at first. On doing so drag

a t t h e s a m e t i m e at clip inclusive pull cord (A1)

and release cord (A2) as shown in fig. 9. On doing so you

have to pull out the pull cord about 10 cm.

It is i m p o r t a n t to release the release cord (A2) at first

and after that the clip inclusive pull cord (A1).

A t t e n t i o n! Important point! Watch your fingers!

Close the window! Are both brackets screwed as seen in fig. 8

you have now to connect the window closer (A) with the window

casement bracket (C). To do so slide the window closer from

left to right across the window casement bracket until it clicks

into place (fig. 10/11).

Fig. 8:

Ready screwed

brackets