6.5

Toolbar buttons:

Button Description

Start Starts the recognition process.

Stop Stops the recognition process.

Lock Locks all the station commands, except for the Unlock command.

Unlock Opens the Unlock Recognition Station dialog box where you can unlock the station commands.

Typical actions of the recognition operator

1. Start the station (select Start>All Programs*>ABBYY FormReader Enterprise Edition>Recognition Station).

2. In the

3. When the station starts, you will be prompted to start recognition. Recognition is performed automatically. If there is a batch that

has not been recognized, recognition of this batch will be resumed when you click Start. If there are no unfinished batches, the

Recognition Station will start recognizing the batches from the Recognition queue. Recognition ends when there are no more

waiting batches in the Recognition queue.

Important!

It is recommended to lock the station commands during the operation of the station.

1. To exit the station, select Recognition>Close Station.

* – For the Windows operating systems lower than XP, select Start>Programs.

Additional capabilities of the Recognition Station

The Recognition Station provides the following additional capabilities:

• Stopping recognition

• Locking the Recognition Station

• Unlocking the Recognition Station

Stopping recognition

To stop recognition, click the Stop button or select Recognition>Stop. The recognition process can be stopped either after the

station completes processing a batch or during processing.

Locking the Recognition Station

To lock the station commands, click the Lock button or select Lock Commands>Lock.

Unlocking the Recognition Station

To unlock the station commands, click the Unlock button or select Lock Commands>Unlock. In the Unlock Recognition

Station dialog box that opens, enter your login and password and click OK.

Important!

If the Recognition Station was locked by another operator, recognition will be stopped and the station closed after you enter your

login and password (first, the station will finish processing the current batch). Run the station again if you wish to resume recognizing

batches.