Use Manual

– Flat bottom
– Pediatric
– Cone bottom
– Sample cup
– Tube with sample cup
– Ridged lip
Tube material
• Approved:
– PET Polyethylene terephthalate
– PP Polypropylene
– PS Polystyrene
– PC Polycarbonate
• Not approved: Glass
Tube height
• Uncapped: 60 mm to 105 mm
• Capped: 60 mm to 110 mm
Diameter
• Uncapped: 10.5 mm to 16 mm
• Capped: 11.5 mm to 18 mm with at least 1 mm overhang
over tube external diameter
Caps
• Approved:
– Safety cap (for example, for vacuum system)
– Screw cap (for example, for aspiration system)
• Not approved:
– Cap with flap
– Rubber stopper closure
– Cap with irregular top edge
– Archiving cap
Cap diameter
11.5 mm to 18.0 mm
NOTE: External diameter of the cap is minimally 1 mm greater
than the tube.
Cap height
> 5 mm
Maximum sample tube fill level
15 mm below tube lip
CAUTION: Do not exceed the maximum sample
tube fill level. Exceeding the maximum fill level
may cause components to become contaminated
by sample matter. Infected sample matter that
leaks from the system may expose the operator to
infections due to skin contact with the sample matter.
Fill level
• Approved: Distance between sample material surface and
top rim of tube is greater than 15 mm.
• Not approved: Distance between sample material surface
and top rim of tube is less than 15 mm.
Performance characteristics and specifications
Technical data
Section 4
84
GLP systems Track Operations Manual
80003968-101 - 2021-09-16