Use Manual

Table Of Contents

Recapper Module

(RM)

The RM uses a conical, plastic cap to

seal tubes before they are stored by

using the track on the Archive II or

before they are manually stored after

output by using the IOM.

Analyzer feed modules

Sample Access Line

(SAL)

The SAL is an interface between the

GLP systems Track and an analyzer.

The analyzer pipettor aspirates the

sample from the sample tube in the

CAR while the CAR is secured at the

aspiration AccessPoint on the SAL.

Related information...

Use or function, page 31

Communication paths, page 35

Communication paths

The following figure shows the communication paths.

Figure 1: Flowchart of communication paths

Legend:

1. Laboratory information system (LIS) with middleware

2. Track Workflow Manager (TWM)

3. Track Sample Manager (TSM)

4. GLP systems Track

The following list describes the communication paths:

1. The LIS sends the requested analyses to the middleware. The middleware then forwards

these analyses to TWM.

2. Using these analyses, TWM creates targets on the GLP systems Track, which are then

communicated to TSM.

3. TSM sends detailed instructions for where the sample should be processed on the track.

4. The track notifies TSM of the current location of the sample and the processing steps that

have been performed.

Section 1

Use or function

GLP systems Track overview

GLP systems Track Operations Manual

80003968-101 - 2021-09-16