User guide

DAMPNG2
0.0
ENTER
DSP.SEC
MEASURE
MEASURE
0.0
ENTER
AO1.SEC
MEASURE
0.0
ENTER
AO2.SEC
MEASURE
0.0
ENTER
SECS
MEASURE
BASIC configuration only
ADVANCED configuration only
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
I-E67-84-1B February,2002 7-9
Figure 7-5. Screen Flow Diagram For
Output/Hold Damping State
Apply Damping on the outputs using Figure 7-5
as a reference and the following procedure:
1) Select the Damping State of Operation
using the SELECT Key.
2) Edit the new damping value using the
Key to increment the blinking digit and
the Key to move to the next digit and
press the ENTER Key to enter the new
value. Press the Exit To MEASURE Key to
escape to the Measure Mode.