User guide

HOLD_D
NO
MEASURE YES
MEASURE
HLD.DO1
OFF
ENTER
STATE
MEASURE
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NO MEASURE YES
HLD.DO2
ON
ENTER
STATE
MEASURE
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
NO MEASURE YES
HLD.DO3
OFF
ENTER
STATE
MEASURE
pH
7.02
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
MEASURE
CALIBRATE
OUT/HOLD
CONFIGURE
SECURITY
DISPLAY
SPT/TUNE
Toggle relay states ON/OFF
If NO and DO1 is
held, release hold.
If NO and DO2 is
held, release hold.
If NO and DO3 is
held, release hold.
I-E67-84-1B February,2002 7-5
Figure 7-4. Screen Flow Diagram For Setting
Specific Relay Output States.
2) Hold all (i.e., HLD.ALL) outputs by
pressing the YES Key, or hold specific
outputs using the NO Key. Press the Exit
To MEASURE Key to escape to the Measure
Mode.
3) For each output, use the YES Key to hold
the indicated output or the NO Key to
release the indicated output. Press the
Exit To MEASURE Key to escape to the
Measure Mode.
4) For held analog outputs, set the hold
value using the Key to increment the