User guide

I-E67-84-1B February,2002 vi
INTRODUCTION ............................15-1
PREVENTIVE MAINTENANCE .......................15-1
Cleaning the Sensor ......................15-2
SECTION 16 - REPLACEMENT PROCEDURES ...................16-1
INTRODUCTION ............................16-1
ELECTRONIC ASSEMBLY REMOVAL/REPLACEMENT ...............16-1
FRONT BEZEL ASSEMBLY REMOVAL/REPLACEMENT ..............16-2
SHELL ASSEMBLY REMOVAL/REPLACEMENT .................16-2
REAR COVER ASSEMBLY REMOVAL/REPLACEMENT ...............16-3
SECTION 17 - SUPPORT SERVICES ......................17-1
INTRODUCTION ............................17-1
RETURN MATERIALS PROCEDURES .....................17-1
REPLACEMENT PARTS ..........................17-1
RECOMMENDED SPARE PARTS KITS ....................17-2
APPENDIX A - TEMPERATURE COMPENSATION .................. A-1
GENERAL ............................... A-1
NERNSTIAN TEMPERATURE COMPENSATION ................. A-1
SOLUTION COEFFICIENT ........................ A-2
APPENDIX B - PROGRAMMING TEXT STRING GLOSSARY .............. B-1
GENERAL ............................... B-1
GLOSSARY OF PROGRAMMING TEXT PROMPTS ................ B-1
APPENDIX C - CONFIGURATION WORKSHEETS .................. C-1
Safety Summary
GENERAL
WARNINGS
Equipment Environment
All components, whether in transportation, operation or storage,
must be in a noncorrosive environment.
Electrical Shock Hazard During Maintenance
Disconnect power or take precautions to insure that contact with
energized parts is avoided when servicing.
SPECIFIC
CAUTIONS
To prevent possible signal degradation, separate metal conduit
runs are recommended for the sensor, signal and power wiring.
Automatic Nernstian With Solution Coefficient compensation can
only be used for processes that are extremely repeatable.